One of our most requested products, Enviro-Safe® ProSeal Xl4 Inject with is a small, concentrated, easy inject refrigerant leak sealant. ProSeal XL4 Inject is compatible with all refrigerants except ammonia. This product performs best in heat pumps, split and mini- split units, packaged units, microchannel coils, coolers, and commercial units.
Enviro-Safe™ has been producing and packaging sealants for over 17 years. Our Sealant Injector hose was designed and tested during 2013/2014 and has been produced and marketed under private label since the fall of 2014.
Unlike most other products on the market, ProSeal XL4 with Dye travels with the gas, which makes it faster, and more effective at finding leaks. ProSeal XL4 with Dye Inject will seal most leaks when used according to the manufacturer’s instructions and will seal most small holes located in the A/C condenser, evaporator, fittings, and metal line sets. Sealing leaks will save energy and lower refrigerant emissions.
*DO NOT use in ammonia systems.
Eliminate the tedius, and time consuming process of "pumping down the unit".
Simply Connect and Inject.
Enviro-Safe's ProSeal XL4 Inject is:
Compatible with all refrigerant, except ammonia
Compatible with all oils
No need to pump down R410, or other units
Large equipment, bulky tools, injection hoses are a thing of the past
For Use In:
Enviro-Safe ProSeal XL4 Inject is currently available in three sizes: Fractional - 1.5 Ton unit, 1.5 - 5 Ton units, and 6-30 ton units.
These items are also available in Bulk:
Professional Use Only
Instructions for use:
Step 1: Turn the a/c system on, and verify the unit is running. Connect ProSeal XL4 Inject to the low side service port of the system. (This is generally the large line.)
Step 2: Connect the manifold refrigerant hose to the refrigerant supply tank. Verify the manifold high & low side valves on the manifold are closed before proceeding. Purge the air from the low side.
Step 3: Open low side valve, watch for the tube to clear. (This will ONLY take a few seconds!) Turn off low side manifold valve as soon as the tube is clear. Turn off refrigerant gas. Verify the system is charged to manufacturer’s specifications. Disconnect low side hose from ProSeal XL4 Inject. Install service port cap. Run the a/c unit at least one hour after installing ProSeal XL4 Inject.
Note: Do Not use Enviro-Safe ProSeal XL4 Inject in any manner it was not designed!